News

Home / News (Page 10)

Selection and disassembly of screw of injection molding machine
11-06-2020
How to decide the screw of injection molding machine In order to avoid material storage, there is no check ring, and the head taper is 20 ° - 30 °. It is more suitable for soft glue. If the product demands higher require...
How to improve the working life of injection screw
05-06-2020
Injection screw works under high temperature, high pressure, high mechanical torque and high friction environment for a long time. The first several factors are required by the process conditions, and the loss caused by ...
The difference between parallel and conical twin screw extruders
28-05-2020
Is parallel twin-screw extruder better or conical twin-screw extruder better? It is a question that users often raise when they choose twin-screw extruder. Classification of twin screw extruders According to the rotation...
What factors affect the working speed of screw of injection molding machine
21-05-2020
First, the working speed of the screw of the injection molding machine is unstable, which is affected by the following factors: 1. The transmission V-belt is seriously worn and slips during operation. 2. The center dista...
What are the characteristics of screw
14-05-2020
Explanation of screw A cylinder with a spiral groove or a cone with a spiral groove. Material requirements It can be seen from the extrusion process that the screw works under high temperature, certain corrosion, strong ...
Discussion on four common screw repair technologies
09-05-2020
1. The twisted screw shall be considered according to the actual inner diameter of the barrel, and the outer diameter deviation of the new screw shall be given according to the normal clearance with the barrel for manufa...